Operating instructions
Operating sweeping
machine without
automotive power
Danger!
Immobilise the machine against
inadvertent movement prior to
engaging the freewheel.
The brake is ineffective once the
freewheel has been engaged.
! Open unit cover, engage stay bar
! Pull freewheel lever up and latch
it in place in this position
— This makes the drive system
inoperable, it is possible to push
the machine
Note:
— When the sweeper is not self-
powered do not move it over
longer distances and not faster
than 6 km/h .
Unloading instructions
Warning!
When the machine is loaded the
freewheel lever must generally be
engaged in its bottom position. Only
then are the drive system and the
parking brake operable.
— The machine was secured on a
pallet with stretch belts or ropes
for safe transport. Proceed as
follows when unloading:
! Cut the plastic packing tape and
remove the film.
! Connect battery (see
maintenance work chapter)
! Remove the blocks for securing
the wheels and drive the machine
off the pallet using a suitable
ramp.
Warning!
Do not use a fork lifter for unloading;
the machine can be damaged by it.
KM 100/100 R D
Before every operation
General notes
! Stand sweeper on a flat surface
! Remove the ignition key
Testing and maintenance
work
! Check engine oil level *
! Check level of the fuel tank *
! Check level of hydraulic oil *
! Check side brushes *
! Check main brush *
! Empty the swept material
container
! Check tyre inflation pressure *
* See maintenance work chapter for
instructions
Commissioning
Warning!
It is not permissible to cover the air
suction openings behind the driver's
seat.
It is not permissible to deposit
objects next to or behind the seat.
Suction openings
English
Adjust driver seat
! Open unit cover, engage stay bar
! Slightly loosen wing nuts of seat
runners
! Push the seat into the
appropriate position
! Retighten wing nuts
Note:
There is a further adjustment
possibility if the adjusting range is
insufficient
25