Driving Over Obstacles; Decommissioning; Transport; Transport Instructions - Kärcher KM 100/100 R D Betriebsanleitung

Operating instructions

Driving over obstacles

Fixed obstacles of up to 50 mm in
height
! Slowly and carefully drive over
them in the forward direction.
Fixed obstacles over 50 mm in
height
! May be driven-over only with a
suitable ramp.

Decommissioning

Please heed the following if
sweeper is not to be used for a
lengthy period:
! Stand sweeper on a flat surface
! Raise the sweep roller and side
broom to prevent damage to the
bristles
! Turn ignition key to "0" and
remove it
! Close fuel shut-off valve
! Secure sweeper to stop it rolling
away
! Clean inside and outside of
sweeper
! Turn off the machine on a
protected and dry place
! Change the engine oil
! Disconnect the batteries
! Recharge the battery at intervals
of approx. 2 months

Transport

Transport instructions

Warning!
When the machine is loaded the
freewheel lever must generally be
engaged in its bottom position. Only
then are the drive system and the
parking brake operable.
Uphill or downhill the machine must
always be moved automotively.
! Turn ignition key to "0" and
remove it
! Empty tank
! Secure the machine with wedges
on the wheels
! Secure the machine with stretch
belts or ropes
Fastening areas
Notes:
Observe markings for fastening
areas on base frame! (chain
symbols)
For loading or unloading the
machine may be operated on slopes
of only up to a max. of 18 %
KM 100/100 R D

Cleaning and maintenance

! Stand sweeper on a flat surface
! Turn ignition key to "0" and
remove it

Internal cleaning

Danger!
Wear dust mask!
Wear safety goggles!
! Open unit cover, engage stay bar
! Clean with a rag
! Blow-out with compressed air

External cleaning

Clean with a damp cloth previously
soaked in mild suds
Note:
Do not use any aggressive cleaning
agents!

Maintenance intervals

Elapsed-time meter

Elapsed-time meter indicates
maintenance interval times.
Maintenance by the
customer
Daily maintenance
! Check the engine oil level
! Check axle drive oil level
! Check the tyre air pressure
! Check roller and side brush for
wear and trapped straps
! Check the function of all
operating controls
Maintenance weekly
! Check air filter
! Check oil level of sweeping
hydraulics
! Check hydraulic hose for leaks
! Check freedom of movement of
Bowden cables and moving parts
! Check setting and wear of
sealing strips in sweeping area
! Check vacuum system (operation
of lowering side brushes)
English
Maintenance every 100 operating
hours
! Enging-oil change (first change
after 20 operating hours)
! Check operation of seat contact
switch
! Checking the battery acid level
! Check tightness, wear and
operation of drive belts (V-belts
and round belts)
Maintenance according to degree
of wear
! Replace sealing strips
! Replacing the sweep roller
! Replacing the side broom
See maintenance tasks chapter for
description
Note:
Where maintenance is undertaken
by the customer, all service and
maintenance work must be carried
out by a qualified employee.
A Kärcher specialist dealer can be
consulted whenever support is
necessary.
29