Operating And Functional Elements - Kärcher KM 170/600 R D Bedienungsanleitung

Operating and Functional El-
ements
Function keys
1 Beacon lamp on/off
2 Horn
3 Blinker switch
Multi-functional display
1 Operating hour counter
2 Charge warning lamp
3 Oil pressure warning lamp
4 Cooling water temperature warning
lamp
5 Motor suction air
6 Warning lamp fuel reserve
7 Preglow indicator light
8 Indicator lamp (not connected)
9 Indicator lamp for sidelights
10 Indicator lamp for dipper
11 Indicator lamp for directional indicator
12 Indicator lamp - forward driving direc-
tion
13 Indicator lamp - reverse driving direc-
tion
14 Tank indicator
Operating elements
1 Drive pedal
2 Brake pedal
3 Tank door
4 Parking brake
5 Blower lever
6 Horn/lighting/blinker (option)
7 Steering wheel
8 Ignition lock
Ignition lock
1 Warning system (option)
2 Ignition key
Filament symbol : Pre-heat
–
Position 0: Switch off engine
–
Position 1: Ignition on
–
Position 2: Start the engine
–
Start up
General notes
Read the operating instructions of the
engine manufacturer before start-up
and follow the safety instructions care-
fully.
Refuelling
Danger
Risk of explosion!
Only use the fuels specified in the Op-
–
erations Manual.
Do not refuel the machine in enclosed
–
spaces.
Smoking and naked flames are strictly
–
prohibited.
Ensure that no fuel reaches the hot
–
open surfaces.
Check fuel level via the tank indicator.
Switch off engine.
Open the side engine panel.
Open fuel filler cap.
Fill in diesel.
Wipe off any spilt fuel and close fuel fill-
er cap.
Operation
Programme selection
1 Transport drive
2 Sweeping with sweep roller
3 Sweeping using roller brush and side
brushes
-
Lock/ release parking brake
Loosen parking brake; press brake
pedal at the same time.
Activate the parking brake; press brake
pedal at the same time.
Pull seat adjustment lever outwards.
Slide seat, release lever and lock in
place.
Check that the seat is properly locked in
position by attempting to move it back-
wards and forwards.
Note:The machine is equipped with a seat
contact switch If the driver's seat is vacat-
ed, the machine is switched off.
1 Blinker switch
2 Parking brake
3 Motor speed adjustment
Sit on the driver's seat.
Bring the direction selector switch into
the middle position.
Lock parking brake.
Engine speed adjustment - push for-
ward by 1/3.
Pre-heat
Insert the ignition key into the ignition
lock.
Turn the ignition key to position "Fila-
ment".
Pre-heat lamp glows.
Start the engine
When the pre-heating lamp goes off,
turn the ignition key to position "II".
If the machine starts, release the igni-
tion key.
Note: Never operate the starter motor for
longer than 10 seconds. Wait at least 10
seconds before operating the starter motor
again.
Set programme selection switch to
"Transport drive".
Move the gas lever all the way to the
front (high speed).
Press brake pedal and keep it de-
pressed.
Release parking brake.
Drive forward
Set the travel direction switch to "for-
ward".
Press accelerator pedal down slowly.
2
Adjusting driver's seat
Starting the machine
Drive the machine
.