Safety Instructions; General Information; Before Operation - Reely Waco Bedienungsanleitung



6. Safety Instructions

In case of damage caused by failure to observe these operating instructions, the guarantee will expire. We will not assume any respon-
sibility for consequential damage!
Nor do we assume liability for damage to property or personal injury caused by improper use or the failure to observe the safety
instructions! The warranty is voided in these cases.
Normal wear and tear and accident and crash damages (e.g. broken propeller or other broken parts) are also excluded from the guarantee and
warranty.
Dear Customer,
These safety instructions are not only for the protection of the product but also for your own safety and the safety of others. Therefore, read this
chapter very carefully before putting the product into operation!
a) General Information
Caution, important note!
Operating the model may cause damage to property and/or individuals. Therefore, make sure that you are properly insured when using the model,
e.g. by taking out private liability insurance. If you already have private liability insurance, inquire about whether the operation of the model is
covered before operating it.
Please note: In some EU countries, you are required to have insurance for any flying models!
• The unauthorized conversion and/or modification of the product is inadmissible for safety and approval reasons (CE).
• The product is not a toy. It is not suitable for children under 14 years of age.
• The product must not become damp or wet.
• If you do not have sufficient knowledge as to how to deal with remote-controlled models, please seek the advice of an experienced model maker or a model
making club.
• Do not leave packaging material lying around unattended. It can become a dangerous toy for children.
• Should any questions arise that are not answered with the help of this operating manual, contact our "Technical Advisory Service" (contact information see
chapter) or another expert.
b) Before Operation
• Ensure that both aerials are placed correctly. For best receiver results, place the aerials at a 90° angle.
• Check the functional reliability of your model and of the remote control system. Watch out for any visible damage such as defective plug connections or
damaged cables. All moving parts of the model must run smoothly but should not have any play in their bearings.
• Charge the flight battery necessary for operation as well as rechargeable batteries in the remote control according to the instructions provided by the
respective manufacturer.
• If batteries are used as the power supply of the transmitter, make sure that there is sufficient remaining capacity (battery tester). If the batteries are empty,
always replace the complete set, never replace individual cells.
• Before operation, always control the settings of the trim slider on the transmitter for the various steering directions and, if necessary, adjust them.
• Always switch on the transmitter first. Then the flight battery of the model may be connected and the model may be switched on. Otherwise, the electric model
plane may show unpredictable responses and the propeller may start unintentionally!
• Always check if the propeller is correctly and securely installed before operating the product.
• Make sure that no objects or body parts are in the range or the suction area of the propeller while it is rotating.
29