During Operation - Reely SKY Condor Bedienungsanleitung

• Before each operation, check the settings of the trim slider on the transmitter for the different steering directions and, if necessary, adjust them.
• To operate your model, always pull out the telescopic antenna to its full length, because otherwise the transmitters has a considerably lower range and the
transmitter output is subject to more stress than usual.
• Always switch on the transmitter first. Then the flight battery of the model may be connected and the model may be switched on. Otherwise, the electric model
plane may show unpredictable responses and the propeller may start unintentionally!
• Check the correct and secure position of the propeller before each operation.
• Make sure that neither objects nor body parts are in the rotating and suction areas of the propeller while it is rotating.
c) During Operation
• Do not take any risks when operating the product! Your own safety and that of your environment depends completely on your responsible use of the model.
You are solely responsible for the safe operation of the model!
• Improper operation can cause serious damage to people and property! Therefore make sure there is sufficient safe distance to persons, animals or objects

during operation.

• Select an appropriate site for the operation of your model airplane.
• Fly your model only if your ability to respond is unrestricted. The influence of tiredness, alcohol or medication can cause incorrect responses.
• Do not direct your model towards spectators or towards you.
• Never point the telescope antenna of the transmitter directly onto the model. This has a considerable negative effect on signal transmission to the model.
• Motor, flight control system and flight battery may heat up during operation of the model. For this reason, wait for 5 to 10 minutes before recharging or replacing
the flight battery.
• Never switch off the remote control (transmitter) while the model is in use. After landing, always disconnect the flight battery first or switch the model off. It is
only after this that the remote control may be turned off.
• In case of a defect or a malfunction, remove the problem before using the model again.
• Never expose your model or the remote control to direct sunlight or excessive heat for an extended period of time.
28