Maintenance; Change Oil; Safety Recommendations; Maintenance Schedule - Ggp Italy Spa R200 Gebrauchsanweisung

6
EN

6. MAINTENANCE

6.1

SAFETY RECOMMENDATIONS

WARNING!
!
cap and read instructions before carrying
out any cleaning, repair or maintenance
operation. Wear proper clothing and work-
ing gloves whenever your hands are at risk.
Do not perform maintenance or repair oper-
ations without the necessary tools and
technical knowledge.
IMPORTANT
Never get rid of used oil, fuel
or other pollutants in unauthorised places.
IMPORTANT
If necessary, you can lift the
front side of your lawnmower or you can tip it
on its right side only, making sure not to spill
any fuel or oil.
6.2

MAINTENANCE SCHEDULE

Follow the hourly or calendar – whichever occur
first – maintenance schedule shown in the fol-
lowing table.
Operation
Check oil level
(see 5.1.1)

Change oil

1)
(see 6.3)
Clean silencer and
engine (see 6.4)
Check air cleaner 2)
(see 6.5)
Oil air cleaner
2)
(see 6.5)
Check spark plug
(see 6.6)
Replace spark plug
(see 6.6)
1) Change oil every 25 hours if the engine is oper-
ating under heavy load or in ht weather.
2) Clean air cleaner more frequently if the
machine is operating in dusty areas.
Remove the spark plug
✔
- -
✔ ✔
- -
✔
- -
✔
- -
✔
- -
✔
- -
✔
- - -
6.3
CHANGE OIL
See the specific chapter (8.1) for the oil to be
used.
WARNING!
!
is warm, being careful not to touch the hot
engine nor the drained oil.
a) Place engine level.
b) Make sure that the fuel tank is not full and
that the cap is properly closed.
c) Clean around oil fill (1).
d) Remove the fillercap (1).
e) Have a container ready (2) to collect the oil.
f) Tip the lawnmower on its right side so that
the oil will drain from the oil fill (3).
g) Place the lawnmower level and top up with
new oil (see 5.1.1).
h) Check the oil level on the dipstick (4). Oil
should be at "MAX" mark.
j) Close the fillercap and wipe off any spilled oil.
NOTE
0.65 liter.
6.4
CLEAN SILENCER AND ENGINE
Silencer must be cleaned when the engine is
cold.
a) Remove from the silencer (1) and its guard (2)
any grass debris or dirt that could cause fire,
- - using a brush or compressed air.
b) Clean the cylinder and cylinder head fins (3)
to ease engine cooling and prevent overheat-
-
ing.
c) Clean the plastic components with a sponge
- -
(4) soaked in water and detergent.
- -
- -
- -
6.5

AIR CLEANER SERVICE

-
Keep the filter clean and oil saturated. Replace it
if broken, cut or with damaged parts.
IMPORTANT
to clean the filtering element.
Drain oil while the engine
The oil capacity is about
Never use compressed air