-
+
+
-
+
-
• Pull the locking pin slightly out of the cable clamp and insert the insulated
cable ends in the clamps.
When doing so, observe the correct wiring, see figure above!
Always connect the positive clamps with one another and then the
negative clamps. A wrong connection will damage all smoke
detectors! Markings illustrating the polarity (+/-) are embossed
next to the cable clamps.
72
Observe the correct polarity!
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
Cable clamp
Installation of cable
in the device using
radio modules:
+
-
-
-
+
-
+
Avoid cable contact
with the loop of the
antenna on the
circuit board!
+