Care And Maintenance; Filter Cleaning - ecofort ecoQ 9L Betriebsanleitung

CARE AND MAINTENANCE

Always switch off the unit and unplug from the mains before cleaning or performing any maintenance.
When it is not in use for a long period it is advised to remove the plug from the plug socket. Do not
use chemical solvents (such as benzene, alcohol or gasoline) as they may cause irreversible damage
to the unit.

Filter Cleaning

The Air-inlet may gather dust easily, please clean it often with a soft, damp cloth. If the filter is covered
by dust, the airflow and the performance of the unit will be affected, it may even cause machine
damage. We recommend that you regularly clean the filters. The dehumidifier must be disconnected
from the socket before maintenance and the filters must be allowed to fully dry before re use.
1. Remove the filters from the unit, and tap the dust away.
2. Clean the carbon and the mesh filter with a vacuum cleaner or soft-
brush
3. If dirt and grease is accumulated wash the mesh filter in hot soapy
water
3. Replace the filters in position as shown in the diagram.
Note: Never use the unit without the antibacterial mesh dust filter. The active carbon filter is optional
and should be replaced if necessary after 1 years of usage. Always remove the filters out of protective
bags before first use.
Optional HEPA filter
There is an optional HEPA filter available for purchase. HEPA filter will enhance the air quality in the
room. Please install the HEPA filter between the filter frame and the active carbon filter as in diagram
77