Maintenance; Disposal Of The Product - ecofort ecodry925 Handbuch

Display Functioning
0 OFF
1 90% U.R.
2 86% U.R.
3 78% U.R.
4 72% U.R.
5 65% U.R.
Tab.A – Functioning modes
Start up
When the plug is connected the display D blinks for 5 seconds and
shows the last functioning mode selected: then, if the functioning mode
is different from zero, the blinking stops.
Shutdown
To switch off the dehumidifier push the button T1 until the value dis-
played is 0. When zero is selected both the green light S1 and the display
D blink.
The defrosting cycle
If the temperature goes below 16°C ice may form on the evaporator: le
electronic board automatically performs the defrosting cycle to melt the
ice and keep free the air flow even at lower temperatures. During the
defrosting cycle the light S3 switches on.
Failures
The display is used by the electronic device to show particular situations
(Tab.B). If an error message is displayed please contact your dealer for
repair.
Display Description
n Temperature probe must be checked
u Humidity probe must be checked
Tab.B – Error messages
Positioning
Pic.7 – Air inlet and outlet
where the dehumidifier is installed, the conditions never exceed the
working limits of the machine (Tab.D);
• the room where the dehumidifier is installed must be closed;
• it is advisable to place the dehumidifier in the coldest point of the
room, where normally the humidity level is higher, possibly near the
power socket.
!
WARNING This dehumidifier is NOT suitable for environ-
ments like laundry, or similar, where splashing or dripping
can keep water inside through the upper air grid.
10
Display Functioning
6 60% U.R.
7 52% U.R.
8 46% U.R.
9 40% U.R.
C ALWAYS ON
The dehumidifier must be simply
placed in the room to be dehu-
midified and started. The Nader
dehumidifiers have the peculiarity
that suck the air from the front
grid and put it out from the top
grid (Pic.7): this means that the
unit can be placed against the
wall, even between two furni-
tures.
To obtain maximum efficiency
keep to the following rules:
• make sure that in the room,
Page 10 of 20

Maintenance

The Nader dehumidifiers need no particular maintenance. It is advisable
to dust them and keep the air intake and outlet grids clean. Contact
your dealer if it should function badly or breakdown. The power supply
cable has an M type connection; in the event of damages, the cable must
be replaced with a similar one only by experienced and qualified staff.
!
ATTENTION: before doing anything on the appliance dis-
connect the power supply by unplugging the machine..
Storage
• Keep the appliance in a room with a temperature between –25°C
and +55°C.
• When the appliance is still packed keep to the instructions on the
box.
• Do not place other heavy material on the box.
Check-up to carry out before and after a
long period of inactivity
Before
• Disconnect the plug and empty the condensate collection tank;
• cover the machine to protect it from dust.
After
• The fan must turn freely without gripping;
• put the machine working following this manual's instructions.

Disposal of the product

Applicable in European Union countries only. The
crossed-out rubbish bin symbol indicates that the pro-
duct must be collected separately from other waste at
the end of its useful life. The user must therefore take
the appliance at the end of its useful life to a special
centre for electrical and electronic waste collection or
hand it back to the retailer on purchasing a new pro-
duct of an equivalent type, on a one-for-one basis.
Proper segregated waste collection of old appliances for subsequent re-
cycling, treatment and environmentally compatible disposal helps avoid
possible negative effects on the environment and health and favours re-
cycling of the materials the product is made of.
Improper disposal of the product by the user entails administrative san-
ctions provided for in the legislation of individual countries.
ENGLISH