Control Panel - ecofort ecoQ 9L Betriebsanleitung

CONTROL PANEL

Power On/Off Button
Used to turn the standby mode on and off. Please note it may take a few minutes for the unit to turn off
once pressed.
Humidity / Timer Display Window
Displays the current Humidity of the room
When Humidity button pressed – Shows desired humidity of room before reverting back to showing
the current humidity.
When timer button pressed - Shows how many hours the timer is set for, before reverting back to
showing the current humidity.
"Full Water" Indicator
The red light will flash when the water tank requires emptying, or when the water tank is not correctly
located within the unit.
On Indicator
Green Light – Indicates the unit is on and the heating element is working.
Red Flashing Light – Anti Tip sensor, detecting the unit is not upright. If the unit has been tipped or
tilted, do not use for at least 24 hours to allow it to dry out.
Fan Speed Button
Used to select the fan speed, the current speed is indicated by the LED Lights above the button.
SLEEP – The unit will run in low fan speed, with a lower heat, ensuring the unit runs as quietly as possible.
STANDARD – The unit will run at medium fan speed, with the high heat setting.
TURBO – The unit will run at high fan speed, with the high heat setting.
Note: Once the air has reached the desired humidity setting, the heater will stop, but the fan will continue
to operate at the set speed for a short period then the unit will stop, resuming operation after 30 minutes
when will check humidity again. If humidity in the room is < set target than the dehumidifier will go to
standby for another 30 minutes; otherwise if humidity in the room is > set target then the dehumidifier will
start dehumidifying. This process ensure energy savings while maintaining the set humidity.
70