Operation; Operational Advice - ecofort ecoQ 9L Betriebsanleitung

When selecting '4 hours' for example the unit will stop operating after 4 hours at the selected humidity
/ fan settings. If the tank becomes full before the finish time, the unit will stop, and the Tank Full LED
will flash.
At any point the timer key can be pressed repeatedly to change the desired duration or until 00 is
displayed to cancel the timer.
If the timer button is used while the unit is turned off (But Plugged in), you can specify the number of
hours until the unit turns on.
Setting the Dehumidification level
Start the unit and leave it for 5-10 minutes on sleep mode (50% RH) until the humidistat is able to
correctly read the humidity within the room.
Press the humidity level key
(CO) to 40% 50% 60% 70%.
Intelligent dehumidification and power saving
Your ecofort ecoQ 9L steady dehumidifier features an intelligent micro CPU that ensure maximum
water extraction with minimum power use for the selection made.
The unit will try to maintain humidity level selected in the room by turning off the heating element
when the desired humidity is reached. Note that according to the space where the unit is used,
obstacles in the direct flow, extra humidity being added at any time, settings selected, as well as
other environmental factors the results may vary.

OPERATIONAL ADVICE

1. Plug to power, press the power button to turn-on the machine; press the power button again to
turn-off the dehumidifier.
2. Make sure water-tank is placed/ fitted correctly. If the water tank is not fitted/placed correctly the
'water full' light
73
to select the desired humidistat controls from continuous operation
e l'unità non funziona.