Password Settings; Delete Sensors - Conrad 75 19 90 Bedienungsanleitung

After completing the functional test, remove the mains adapter and connect it again.
Insert the batteries again in the correct polarity. The alarm system is now in normal
operating mode.

8.2 Password Settings

The password is used to arm or disarm the alarm system. The factory password is
1234. However, we recommend setting an individual password. For this purpose,
proceed as follows:
Step 1: Press and hold the "LEARN" button (10).
Step 2: Holding the "LEARN" button (10), also press the button "ARM" (4)
until you hear a beep and the green status LED "POWER" (6) flas-
hes.
Step 3: Now release the buttons.. Enter the current password. You will hear
two beeps.
Step 4: Enter the new password. You will hear two beeps again.
Step 5: Enter the new password again as confirmation. There is a long beep,
the "POWER" status LED (6) stop flashing and is permanently lit. The
new password was stored and can now be used.
8.3 Cancel Sensors
When deleting sensors from an alarm zone, all sensors programmed to this alarm
zone will be deleted at once.
Proceed as follows:
Step 1: Press and hold the button "LEARN" (10). There is one beep.
Step 2: Holding the button "LEARN" (10), press the button for the respective
alarm zone (button 1, 2, 3 or 4) at the same time. Keep both buttons
pressed for 5 seconds until two beeps sound and the "zone status
LED" (3) flashes twice.
Step 3: Release the buttons.. The sensors for the alarm zone pressed are
now deleted.
35