Test Mode - Conrad 75 19 90 Bedienungsanleitung

programme the radio remote control, press the red button (= "Panic"
button) on the remote control.
Step 4: There is a long beep and the "Zone-Status-LED" (3) stop flashing.
The sensor is now programmed
You can programme up to 4 remote controls (1 per zone).
Observe that the motion detector does not signal in alarm zones 1 –
3 in the deactivated state or for "internally activated".
Additionally, also observe the operating instructions of the sensors
used with this alarm system.

8.1 Test Mode

In test mode, the function of the programmed sensors can be tested. This is of
advantage to prevent wrong installation in case the radio range is lowered by obsta-
cles, so that the programmed sensor must be relocated to an alternative installation
site.
To put the alarm system in test mode, proceed as follows:
Step 1: Remove the mains adapter and all batteries.
Step 2: Press and hold the button "MUTE" (9) and connect the mains adap-
ter again while pressing the button "MUTE" (9). All LEDs light up.
Now let go of the "MUTE" (9) button. The system is now in test mode.
Step 3: Set the "alarm mode selection switch" (11) to "ALERT". Activate the
desired sensor.
Step 4: The respective "zone status LED" (3) flashes and there is a number
of beeps corresponding to the number of the respective alarm zone
(1 tone – break – one tone – break = alarm zone 1 ... ; 2 tones -
pause 2 tones – pause... = alarm zone 2 ...; etc).
34