Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ME-32
AC
V
0
10
20
30
40
/
R-H
ON/OFF
PNP NPN
E
E
B
B
C
C
TEMP
4n
?
E
E
hFE
400n
?
DIODE
4mA?
Ω??
400mA?
Vm
20A?
AUTO RANGE
DMM
CAT ll
200mA
1000 V DC
MAX
FUSED
750 V AC
MAX
MAX ?? EACH??
500V MAX
20A
m A
COM
V/Ω
Then switch the measuring appliance and the computer on.
b) Using the optional software (not supplied with the multime-
ter)
The MS-DOS program is called DIGISCOP and is supplied on a dis-
kette in the INSTALL directory. The Windows program is also
called DIGISCOP and is stored on another diskette in the SETUP
directory.
How to use the MS-DOS software:
Important!
The following installation procedure(s) assume you have basic
knowledge of various MS-DOS commands and your computer
has a hard disk. If you have little or inadequate basic knowledge
of MS-DOS commands, you should first read the MS-DOS
Manual on how to install software. A VGA monitor (and a VGA
card installed in the computer) are also required in order to run
the software.
28
1. Insert the diskette into the appropriate drive (A or B or the
like).
2. Run "install.bat" - this installs the program on your PC.
3. To start the program, type in "digiscop.exe" and confirm by
pressing the enter key.
Important!
To stop the program or if an ERROR occurs, reboot the computer
(press Ctrl, Alt and Del simultaneously).
How to use the Windows software:
Warning!
The following program steps assume some basic knowledge of
MS Windows. If you are not sure what to do, please read about
how to use WINDOWS in the Windows Manual. Running this
software requires Windows version 3.1 or later and a VGA moni-
tor (display).
1. Switch on your computer and start Windows.
2. Insert the diskette into the relevant drive (a or b).
3. In Program Manager, open the File menu and click "RUN". A
menu window with a command line then appears.
4. Enter the following at the flashing cursor:
a:\setup and press Enter if the diskette is in drive a,
b:\setup and press Enter if the diskette is in drive b
5. Follow the instructions on the screen in order to complete
installation.
29
Werbung
Kapitel
