I) Controlling The Vehicle - Reely Generation X 3S Bedienungsanleitung

i) Controlling the vehicle

Place the vehicle on the ground. Do not reach into the motor or hold the wheels.
The following images are for reference purposes only and do not necessarily correspond to the design of
the remote control included with the product!
1. Release the throttle/brake lever (move it to the neutral position). The vehicle should roll to a halt or stay stationary
(if necessary, adjust the throttle trim on the remote control).
2. Slowly pull the throttle/brake lever towards the handle to make the vehicle move forwards.
3. Move the throttle/brake lever away from the handle without a pause to make the vehicle move forwards and brake
(the vehicle decelerates quickly rather than coming slowly to a standstill).
Move forwards, brake and reverse: Move the throttle/brake lever away from the handle without a pause (brake).
If the vehicle is stationary, briefly move the throttle/brake lever to the neutral position (for approximately one sec-
ond), and then move the throttle/brake lever away from the handle (the vehicle will start to reverse).
Move forwards
Pulling the throttle/brake lever from forwards to reverse without a pause will activate the brakes (the vehicle will not
reverse).
To switch from forward throttle to reverse, move the throttle/brake lever away from the handle into the neutral position
(if the vehicle is moving forwards, the brake will be engaged). Then move the lever away from the handle again to
make the vehicle reverse.
If the vehicle is moving forwards and you wish to make it reverse, the throttle/brake lever has to be moved
away from the handle two times. This prevents the motor from being overloaded due to a sudden change
from forwards to reverse throttle.
48
Brake If the vehicle is station-
ary, wait for a moment
(one second).
Reverse