E) Inserting The Vehicle Battery; F) Connecting The Vehicle Battery To The Speed Controller - Reely Generation X 3S Bedienungsanleitung

e) Inserting the vehicle battery

Warning!
Switch on and configure the remote control before connecting the vehicle battery to the speed controller
(see sections 9. c) and 9. d).
Important!
This vehicle is only suitable for use with a 3-cell LiPo drive battery (11.1 V nominal voltage), a 2-cell LiPo
battery (7.4 V rated voltage) or a 6-cell NiMH drive battery (7.2 V nominal voltage).
Using a drive battery with more cells may make the speed controller overheat and cause a fire. In addition,
the powertrain may be damaged due to overload (e.g. differential), which will void the warranty/guarantee!
Check whether the battery has a suitable connector system for the speed controller and that the polarity is
correct (red cable = positive/+, black cable = negative/-).
Remove the two clips (B) and lift the frame (A) off the bat-
tery holder.
Insert the vehicle battery. Ensure that the connection ca-
ble is behind the battery, otherwise the cable may impair
the steering mechanism.
Replace the frame and secure it in place with the clips that
you previously removed.

f) Connecting the vehicle battery to the speed controller

Place the vehicle on a suitable support (or a start box) so that the wheels can move freely. This ensures
that you will not lose control of the vehicle if the wheels move suddenly (e.g. if the throttle trim is not set
correctly).
Do not reach into the motor or hold the wheels in place.
Switch off the speed controller (move the switch to the
"OFF" position). The on/off switch is located between the
speed controller and the receiver box (see right-hand im-
age). The setup button (B) is located next to the on/off
switch (A). This button can be used to program the speed
controller (see section 10).
Switch on the remote control (see sections 9. c) and 9. d).
Connect the vehicle battery to the speed controller. En-
sure that the battery is inserted in the correct polarity (red
cable = positive/+, black cable = negative/-).
Do not use any force when connecting the battery to the speed controller. Ensure that cable cannot get caught in the
motor/steering mechanism. If necessary, use cable ties to fix the cable in place.
46