Operation; A) Removing The Chassis; B) Installing The Antenna Cable For The Receiver; C) Inserting Batteries Into The Remote Control - Reely Generation X 3S Bedienungsanleitung

9. Operation

a) Removing the chassis

Remove the clips and lift the chassis off the vehicle.

b) Installing the antenna cable for the receiver

Guide the antenna cable through the antenna tube (A) and
insert it into the corresponding support (B) on top of the
vehicle.
To improve the range, the antenna should protrude verti-
cally from the vehicle.
Never wind the aerial cable, as this significantly reduces
the transmission range.
Take care not to damage the antenna cable. Never at-
tempt to shorten the cable!

c) Inserting batteries into the remote control

Open the battery compartment on the remote control and insert new or fully charged batteries. Ensure that the
batteries are inserted in the correct polarity (observe the positive/+ and negative/- markings). Replace the battery
compartment cover.
Read the remote control instructions included with the product.

d) Configuring the remote control

Switch on the remote control and set the steering and throttle trim to the central position. If the remote control has a
dual rate feature, disable it or adjust it so that the steering angle is not limited.
Read the remote control instructions included with the product.
45