Start-Up; A) Removing The Car Body; B) Installing The Receiver Aerial Cable; Inserting The Driving Battery In The Vehicle - Reely Alu Fighter Bedienungsanleitung



8. Start-Up

a) Removing the Car Body

The car body is fastened to the car with holding brackets that have to be slid out of the retaining pins. The car body can
then be lifted off.

b) Installing the Receiver Aerial Cable

Unwrap the aerial cable completely and smooth it out carefully. For this, hold the aerial cable near the receiver with two
fingers (do not hold the receiver but the cable) and then pull the cable straight repeatedly with two fingers of your other
hand.
The receiver and the aerial cable are located in the closed receiver box. Open the receiver box by un-
screwing the four screws of the cover and removing the cover.
To protect the receiver from vibrating, we recommend wrapping it in foam before closing the receiver box
again.
Then insert the aerial cable through the holder in the receiver box cover from below.
Guide it through the aerial tube and plug the aerial tube into the respective holder in the receiver box cover. Simply let
excess aerial cable protrude loosely from the tip of the aerial tube.
If a rubber cap for the aerial tube is enclosed; it prevents the dislocation of the aerial cable after it is attached to the tip.
Never shorten the aerial cable! Never roll up the aerial cable! This greatly reduces the range.
Close the receiver box again carefully, replace the cover and screw it down tightly.
c) Inserting the Driving Battery in the Vehicle
Attention!
The driving battery must not be connected to the speed controller yet.
Loosen the hook and loop tapes of the battery holder and place the driving battery in the battery holders. Tighten the
hook and loop tapes again before closing them.
The following driving batteries can be used for operating the speed controller/vehicle
- one 4-cell LiPo battery (rated voltage 14.8 V)
- one 12-cell NiMH battery (rated voltage 14.4 V)
- two 2-cell LiPo batteries (rated voltage 7.4 V each) via the included Y-adapter
- two 6-cell NiMH batteries (rated voltage 7.2 V each) via the included Y-adapter
36