Transmitter Controls - Reely Rock Crawler Bedienungsanleitung



7. Transmitter controls

1 Telescopic antenna
You can unscrew the telescope antenna for transport
if desired.
2 LC display
3 On/off switch
This slide switch switches the transmitter on and
off. Never switch the transmitter off when the vehicle
is being operated!
4 Charging socket to charge batteries in transmitter
5 Control button for settings menu
6 Power LED
7 "DT3" rocker button for dual rate for steering function
8 "DT4" rocker button for trimming rear axle steering
9 Switching button for steering
10 Lever for forward/reverse drive
With this lever, you control the drive and the brake
function of the vehicle.
11 Rotating wheel for steering
12 "DT1" rocker button for trimming front axle steering
13 "DT2" rocker button for trimming/neutral setting of drive
14 The changeable crystal (located on the rear side of the transmitter)
A crystal with the same frequency must be inserted in the transmitter and in the receiver.
The transmitter crystals are generally labelled "T" or "TX", the receiver crystals are marked "R" or "RX" . Do not
mix up the two crystals!
15 Battery compartment
Insert 8 batteries type AA/mignon here or 8 rechargeable batteries (observe the correct polarity!). The correct
polarity is indicated in the battery compartment.
30
1
2
3
4
5
6
7
8
13 12 11
10
9
15
Figure 1
14