Reely 23 31 71 Bedienungsanleitung Seite 58

• Please note:
If the reverse function is active, the direction display "RB"
will appear on the display as soon as you are steering
left. In this case it isn't the left but, as shown on the dis-
play, the right steering turn that is changed electronically.
This is why at this moment, you can see no change of the
steering angle from the wheels that are turned left.
In order to mechanically check this changed value, sim-
ply turn until the right limit stop. At this moment the di-
rection display changes to "LF" and you could now set
the steering to the left.
• With the channel shift button (see picture 1, pos. 5) you
can now switch to channel 2 (throttle servo) and set the
necessary values according to the same procedure as
with channel 1.
• Illustration 10a shows the final settings of the throttle
servo (1) when the operating lever for the drive function
(see illustration 1, pos. 8) was pulled from its centre po-
sition up to the limit stop in the direction of the handle.
The slide carburettor (2) is fully opened. To illustrate this
more clearly, the air filter was pulled off the carburettor
adapter.
If need be, the position of the adjusting ring (3) can be
changed, if the EPA value has to be reduced too much.
• Illustration 10b shows the end position of the throttle
servo (1), when the operating lever for drive function is
pushed from its centre position forward to the limit stop
(brake position).
The slide carburettor (2) is closed except for a small gap
and the break lever (4) is actuated with maximum force.
If need be, the rods can be changed with an adjustment
ring (5) and thus the break function can be adjusted.
58
Illustration 9c
Illustration 9d
Illustration 10a
Illustration 10b