Setting Up And Mounting - Renkforce DL-PAR101 LED-Spot 77 LEDs Bedienungsanleitung

9. Setting up and mounting

The setup and the installation of the device must be carried out by a specialist who is familiar
with the hazards and the relevant regulations. Maintenance, operation and commissioning of
this device must only be carried out by qualified persons.
When choosing a location for your device, ensure that you avoid impacts, vibrations, dust, hot
and cold temperatures and damp environments. In addition, no powerful transformers or motors
should be used close to the device.
The LED spot must only be used in places with a maximum ambient temperature of 40 °C.
Never cover the device. Ensure sufficient ventilation when setting up the device with other
equipment. Maintain a sufficient distance to other devices and walls. Never place the LED spot
in direct proximity of heat sources. Do not point any strong spotlights or light sources at the
device. This may cause the device to overheat (fire hazard!).
Do not drill or screw additional screws into the casing in order to secure the device. This may
expose you to a dangerously high voltage when the device is touched.
The device must be mounted out of normal reach.
Illuminated objects must be at least 0.5 m away from the device's light emission source.
Highly flammable materials such as decorative fabrics must also be kept at a distance of at least
0.5 m from the device in order to prevent a fire hazard!
When mounting the product, make sure that the power cord is neither jammed nor damaged by
sharp edges.
During installation or service work, the area below the place of installation must be cordoned
off.
The setup/installation surface or fixture must be designed to carry ten times the load capacity
for at least one hour without causing any permanent damage or deformation.
It is also essential that the device is secured by means of a second safety restraint that is
independent of the actual mounting supports when installing it in an elevated position. No part
of the installation should fall down if the main suspension system fails.
Observe all relevant regulations for your country when mounting/installing the device.
Acceptance test (for industrial/public use):
Before first use and after any significant modifications, the installation (including the electrical
connections) must be inspected by an expert.
An inspection must be carried out annually by a technician.
An acceptance test must be carried out by an expert at least once every 4 years.
• The LED spot can be mounted using the mounting brackets (7) and thumb screws (6). Mount the light on
the ceiling, the wall or another suitable traverse system using the mounting brackets. The assembly must
never swing freely. Secure the device with mounting materials that are suitable for the mounting surface
and for carrying the load of the LED spot.
38