B) Setting Up A Master Slave Chain; Mains Connection - Renkforce LV-DJ13 Bedienungsanleitung

b) Setting up a master slave chain

The effect light can be operated controlled by a DMX controller or in a master-slave chain. In that case, the integrated
controller of the master device controls the connected LV-DJ13 LED effect devices.
You can operate a maximum of 20 devices in a DMX chain without overloading the controller.
• Connect the DMX OUT port of the master device to the DMX IN port of the first slave device.
• Connect the DMX OUT port of the first slave device to the DMX IN port of the subsequent LV-DJ13 device.
• Proceed as described above with all remaining slave devices.
• Plug an XLR plug with a terminating resistor into the DMX OUT connection of the last slave device (as described in
section "Connection of a DMX Controller").

9. Mains connection

The mains socket to which the effect light is connected must be close to the device and easily ac-
cessible to quickly separate the device from the mains voltage in case of an error.
Be careful when handling mains cables and mains connections. Mains voltage may cause poten-
tially fatal electric shock.
Make sure that no cables lie around openly. Install cables professionally to prevent accidents.
Before plugging in the mains plug, ensure that the device voltage indicated at the effect light cor-
responds to the available mains voltage. Do not connect the device if the indication does not cor-
respond to the available mains voltage. Incorrect supply voltage may lead to irreparable damage to
the device and danger to the user.
• Connect the low-voltage connector of the mains cable to the IEC mains socket of the device.
• Plug the mains plug of the mains line into a grounded socket.
• Once the device is connected to the mains socket, it takes up operation.
21