Set-Up And Installation - Renkforce TT-016B Bedienungsanleitung

8. Set-up and installation

Have an expert who is familiar with the dangers and applicable regulations install and assemble
the device. Only properly qualified persons may service, control or operate this device.
When choosing the location for installation, make sure it is free from impact, vibration, dust,
heat, cold and humidity. Also make sure there are no powerful transformers or engines located
near the device.
Use the LED spotlight in areas with an ambient temperature of maximum 40 ºC only.
Never cover the device. When installing the device together with other equipment, ensure
sufficient ventilation. Leave sufficient distance to other equipment and to walls. Do not place
the LED spotlight in the direct vicinity of heat sources. Do not point any strong beamers or light
sources at the device. This could cause overheating (risk of fire!).
Do not drill or screw any additional screws into the housing for installation. This could expose
dangerous voltages.
Install the device out of other persons' arm's reach.
There must be a distance of at least 0.5 m between illuminated objects and the light output of
the device.
Make sure to also leave a distance of at least 0.5 m between the device and easily flammable
objects such as decorative material. Otherwise there is a risk of fire!
When installing the product, make sure not to squeeze the mains cable or to damage it by sharp
edges.
When installing or servicing the device, seal off the area below the installation location.
Use a mounting surface or mounting device that can withstand the tenfold load capacity for at
least one continuous hour without permanent dangerous deformation.
When choosing an elevated location for installation, it is essential to secure the device with a
second safety suspension separately from the actual mounting device. If the main suspension
malfunctions, neither of the installed components must fall down.
Adhere to all regulations in your country concerning this matter when assembly/installing the
device.
Inspection of the installation (for commercial/public use):
An authorized expert must inspect the installation (including the electric connection) before
first-time operation and after the installation has been changed significantly.
Have the installation inspected once a year by a qualified person.
It is mandatory to have the installation inspected by an authorized expert at least once every
4 years.
26