Maintenance Interval Table; Maintenance Intervals; Oiling The Saw Chain; Sharpening The Saw Chain - FLORABEST 87800 Originalbetriebsanleitung

GB

Maintenance Interval Table

Machine part
Components of the chain
brake
Sprocket chain wheel
Saw chain (5)
Guide bar (4)

Maintenance intervals

Regularly carry out the maintenance opera-
tions listed in the following table. The life
of the saw is extended by regular main-
tenance of your chainsaw. Furthermore,
you get optimum cutting performance and
avoid accidents.

Oiling the saw chain

Clean and oil the chain regularly.
In this way, you keep the chain
sharp and get optimum machine
performance. In case of damage
due to inadequate maintenance of
the saw chain, the guarantee claim
is invalid.
Remove the power plug and use
cut-protection gloves when you are
handling the chain or the chain bar.
• Oil the chain after cleaning, after 10
hours of use or at least once weekly,
depending on which comes first.
• Before oiling, the chain bar must be
cleaned thoroughly, in particular the
teeth of the rail. Use a whisk and a dry
cloth for that.
20
Action
Check, replace if required
Check, replace if required
Check oil, regrind or re-
place if required
Check, turn round, clean
and oil
Before
every
use




• Oil the individual chain links with the
aid of an oil suction gun with pinpoint
tip (available in the specialist trade).
Place individual oil drops onto the ar-
ticulated links and onto the tooth tips of
the individual chain links.

Sharpening the saw chain

An incorrectly sharpened
saw chain increases the dan-
ger of spring-back!
Use cut-protection gloves
when you are handling the
chain or the chain bar.
A sharp chain guarantees an op-
timal cutting performance. It eats
effortlessly through the wood and
leaves large, long wooden chips.
A saw chain is blunt if you have to
press the cutting equipment through
the wood and the wooden chips
are very small. In the case of a very
blunt saw chain, no chip cuttings
result at all, only sawdust.
• The sawing parts of the chain are the
cutting elements, which consist of a cut-
ting tooth and a depth limiting projec-
After 10 hours
of operation
