Oiling The Saw Chain; Sharpening The Saw Chain; Maintenance Interval Table - FLORABEST FKS 2200 E3 Originalbetriebsanleitung

Maintenance Interval Table

Machine part
Components of the
chain brake
Sprocket chain wheel
(25)
Saw chain (5)
Saw chain (5)
Guide bar (4)
Guide bar (4)
Oil automatic system

Oiling the saw chain

Clean and oil the chain regularly.
In this way, you keep the chain
sharp and get optimum machine
performance. In case of damage
due to inadequate maintenance of
the saw chain, the guarantee claim
is invalid.
Remove the power plug and use
cut-protection gloves when you are
handling the chain or the chain bar.
• Oil the chain after cleaning, after 10
hours of use or at least once weekly,
depending on which comes first.
• Before oiling, the chain bar must be
cleaned thoroughly, in particular the
teeth of the rail. Use a whisk and a dry
cloth for that.
• Oil the individual chain links with the
aid of an oil suction gun with pinpoint
tip (available in the specialist trade).
IB-270730-FKS_2200_E3-RO-BG-GR-03112015-rev03-ts.indb 21
Action
Check, replace if
required
Check, replace if
required
Check oil, regrind or
replace if required
Clean and oil
Check, clean and oil
turn around
check and, where
appropriate, clean oil
outflow duct
Place individual oil drops onto the ar-
ticulated links and onto the tooth tips of
the individual chain links.

Sharpening the saw chain

Before After 10
every hours
use of operation






An incorrectly sharpened
saw chain increases the dan-
ger of spring-back!
Use cut-protection gloves
when you are handling the
chain or the chain bar.
A sharp chain guarantees an op-
timal cutting performance. It eats
effortlessly through the wood and
leaves large, long wooden chips.
A saw chain is blunt if you have to
press the cutting equipment through
the wood and the wooden chips
are very small. In the case of a very
blunt saw chain, no chip cuttings
result at all, only sawdust.
GB
After
every use


21
04.11.15 12:47