Chain Saw Safety Warnings - FLORABEST 87800 Originalbetriebsanleitung

GB
controlled with the switch is dangerous
and must be repaired.
Disconnect the plug from the
•
power source and/or the bat-
tery pack from the power tool
before making any adjust-
ments, changing accessories, or
storing power tools. Such preven-
tive safety measures reduce the risk of
starting the power tool accidentaIly.
Store idle power tools out of the
•
reach of children and do not al-
low persons unfamiliar with the
power tool or these instructions
to operate the power tool. Power
tools are dangerous in the hands of
untrained users.
Maintain power tools. Check
•
for misalignment or binding
of moving parts, breakage of
parts and any other condition
that may affect the power tool's
operation. If damaged, have
the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
Keep cutting tools sharp and
•
clean. Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
Use the power tool, accessories
•
and tool bits etc. in accordance
with these instructions, taking
into account the working condi-
tions and the work to be per-
formed. Use of the power tool for op-
erations different from those intended
could result in a hazardous situation.
• For sawing work on a slope, always
stand above the tree trunk. To keep con-
trol at the moment of "sawing through",
reduce the contact pressure at the end
of the cut without loosening the firm grip
on the chainsaw handles. Ensure that the
10
saw chain does not come into contact
with the ground. After completing the
cut, wait for the chainsaw to come to a
standstill before removing the chainsaw.
Always switch off the chainsaw motor
before moving from one tree to another.
• Dirt, stones, loose bark, nails, staples
and wire must be removed from the tree.
Service
Have your power tool serviced
•
by a qualified repair person us-
ing only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.

Chain saw safety warnings:

Keep all parts of the body
•
away from the saw chain when
the chain saw is operating. Be-
fore you start the chain saw,
make sure the saw chain is not
contacting anything. A moment of
inattention white operating chain saws
may cause entanglement of your cloth-
ing or body with the saw chain.
Always hold the chain saw with
•
your right hand on the rear
handle and your left hand on
the front handle. Holding the chain
saw with a reversed hand configura-
tion increases the risk of personal in-
jury and should never be done.
Wear safety glasses and ear
•
protection. Other protective
equipment for the head, hands,
legs and feet is compulsory. Ad-
equate protective clothing will reduce
personal injury by flying debris or ac-
cidentaI contact with the saw chain.
Do not operate a chain saw in a
•
tree. Operation of a chain saw white