Tensioning The Saw Chain; Chain Lubrication; Filling Up With Chain Oil - FLORABEST 87800 Originalbetriebsanleitung

Tensioning the saw chain

With a correctly tensioned chain you get
good cutting performance and a longer
life.
An incorrectly tensioned
chain may break or spring
off, leading to danger of
injury. Test the electric saw
before every start and the
chain tension after every
hour of sawing.
The chain is correctly tensioned if it does
not sag at the rail underside and can be
rotated completely around with the gloved
hand.
When the saw chain is tensioned with 9 N
(approx. 1 kg), the gap between the saw
chain and the guide rail may not be more
than 2 mm.
1. Ensure that the chain brake has
B
been released, that is, that the
chain brake lever (3) is pulled up
against the front grip (8).
2. Unscrew the fastening bolt (14).
3. To tighten the saw, turn the chain
adjustment ring (13) clockwise.
To loosen the tension, turn the
chain adjustment ring anti-clock-
wise.
4. Tighten up the fastening bolt (14)
again.
With a new saw chain, you must
readjust the chain tension after at
least 5 cutting operations.

Chain lubrication

The rail and chain must never be
without oil. If you operate the elec-
tric chainsaw with too little oil, the
cutting performance and the lifetime
of the saw chain is reduced, since
the chain becomes blunt faster. You
can identify a case of too little oil
where smoke development or dis-
coloration of the rail occurs.
The chainsaw is equipped with an auto-
matic oiling system. As soon as the motor
is speeded up, the oil also flows faster to
the chain bar (4).

Filling up with chain oil:

• Check the oil fill level and regularly top
up with oil ( C
270 ml oil.
• Use Parkside bio-oil; this product con-
tains additives that reduce wear and
tear and does not damage the pump
system. bio-oil is available from our
Service-Center.
• If you have no Grizzly bio-oil available,
use chain lubrication oil with low adhe-
sive additive content.
1. Unscrew the oil fill cap (2) and fill
C
up with chain oil.
2. Wipe off any spilled oil and
close the cap again.
Always switch off the device
and allow the motor to cool
before filling with chain oil.
There is a risk of fire if oil
overflows.
20). The oil tank holds
GB
13