Maintenance And Cleaning; Maintenance Interval Table - FLORABEST FKS 2200 E3 Originalbetriebsanleitung

GB
cutting line is at least 1/10 of the
trunk diameter. The part of the
log not sawed through is desig-
nated as a break dimension.
Insert a felling wedge or a crow-
R
bar into the back cut, as soon as
the depth of cut permits this, in
order to prevent a jamming of the
chain bar.
5. If the trunk diameter is larger than
S
the length of the chain bar, make
two cuts.
For safety reasons, we ad-
vise inexperienced users not
to fell any logs with a rail
length which is smaller than
the trunk diameter.
6. After carrying out of the back cut,
the tree falls by itself or with the
aid of the felling wedge or crow-
bar.

Maintenance Interval Table

Machine part
Components of the
chain brake
Sprocket chain wheel
(25)
Saw chain (5)
Saw chain (5)
Guide bar (4)
Guide bar (4)
Oil automatic system
46
Action
Check, replace if
required
Check, replace if
required
Check oil, regrind or
replace if required
Clean and oil
Check, clean and oil
turn around
check and, where
appropriate, clean oil
outflow duct
As soon as the tree begins to
fall, pull out the saw from the
section, stop the motor, place
the electric chainsaw down
and leave the workplace us-
ing the withdrawal path.

Maintenance and cleaning

Basically, carry out mainte-
nance and cleaning works
with switched-off motor and
power plug removed. Danger
of injury!
Leave any maintenance and
servicing work not covered
by this manual to our Serv-
ice-Center. Use only original
spare parts.
Allow the machine to cool
down before all maintenance
and cleaning works. Danger
of burn injuries!
Before
every
use of operation





After 10
After
hours
every use


