Troubleshooting; Technical Data - Cleanmaxx Z 04380 - SLX225C Gebrauchsanleitung

Troubleshooting

If the device should stop working properly, fi rst check whether you are able to correct the
problem yourself. Otherwise, contact our customer service department.
Do not try to repair a faulty device yourself!
Problem
The device only works slowly
or does not start.
Low suction force.
Dust escapes from the device
during cleaning.
The control lamp does not
light up when the device is
connected to the mains power.

Technical Data

Device
Model number:
Article number:
Voltage supply:
Power:
Battery charge time:
Battery operating time:
Mains adapter
Model number:
Voltage supply:
Output:
Protection class:
Possible cause / solution
• Is the battery fl at? Recharge it.
• Is the collecting container full? Empty it.
• Is the fi lter heavily clogged up? Clean it.
• Is the suction opening blocked?
Switch off the device and remove the blockage.
• It is also possible that some smaller items will remain
stuck to the carpet or are too big / heavy to be picked
up by the device. Remove these foreign bodies by
hand.
• Check whether the collecting container and fi lter are
inserted correctly and adjust the fi tting if necessary.
• Is the charger plugged correctly into the plug socket
and is the barrel connector in the connecting socket of
the device?
• Is the plug socket defective? Try another plug socket.
• Check the fuse of your mains connection.
SLX225C
Z 04380
5.5 V DC, 200 mA
30 W
approx. 14 hours
approx. 15 minutes (with fully charged battery)
TDUB-63I
230–240 V~ 50 Hz
5.5 V DC, 200 mA
II
21