Safety Instructions; Symbols And Icons; General Safety Instructions For Power Tools; Safe Operation - Parkside PSS 65 A1 Betriebsanleitung

manual can therefore not be considered as
valid.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning!
The vibration emission value may
differ during actual use of the
power tool from the stated value
depending on the manner in which
the power tool is used.
Safety precautions aimed at protect-
ing the user should be based on
estimated exposure under actual
usage conditions (all parts of the
operating cycle are to be consid-
ered, including, for example, times
during which the power tool is
turned off and times when the tool
is turned on but is running idle).

Safety Instructions

Symbols and icons

Symbols on the device:
Warning!
Read the instruction manual.
Wear ear protection.
Risk of electric shock! Disconnect
from the mains before carrying out
maintenance and repair work.
Safety class II
Do not dispose of electrical equip-
ment in household waste.
Symbols in the manual:
Warning symbols with in-
formation on damage and
injury prevention.
Instruction symbols (the instruction is
explained at the place of the excla-
mation mark) with information on
preventing damage.
Help symbols with information on
improving tool handling.
General Safety Instructions
for Power Tools
WARNING! Read all safety
instructions and guidelines ca-
refully. Failure to follow the safety
instructions and guidelines may result
in electric shock, fire and/or serious
injuries.
The term „power tool" used in the safety inst-
ructions refers to mains-operated electric tools
(with a mains cable) and to battery-operated
electric tools (without a mains cable.

Safe operation:

Keep work area clear. Cluttered
•
areas and benches invite injuries.
Consider work area environ-
•
ment.
- Do not expose tools to rain. Do not
use tools in damp or wet locations.
Water entering a power tool will incre-
ase the risk of electric shock.
- Keep work area well lit.
GB
21