Switching On And Off; Maintenance And Cleaning - Parkside PWS 230 A1 Betriebsanleitung

hot during use. Do not touch them until after
they have cooled down.
N OTE: Always ensure the discs are free of dirt
before use.
U se only abrasive consumables or tools with
an allowable speed at least as high as the
no-load speed of the device.
D ANGER OF INJURY! Press the spindle lock
button only after the mounting spindle
11
has reached a standstill.
P ress the spindle lock button
R elease the clamping nut
(see Fig. C).
17
P lace the roughing / grinding or cutting disc on
to the mounting flange
facing towards the device.
T hen replace the clamping nut
raised side facing upwards, on to the mounting
spindle .
14
P ress the spindle lock button
T ighten the clamping nut
spanner .
17
N OTE: Replace a new disc immediately if it
runs unevenly or vibrates after being exchanged.
A fter replacing a disc let the device run under
no-load conditions for 30 seconds as a safety
check. Look out for unusual noises or generation
of sparks. Check that all the fastened-on parts
are correctly attached.
P ay attention to see that the arrow showing the
direction of rotation on the roughing / grinding
or cutting discs (including diamond cutting discs)
corresponds with the direction of rotation of the
device (see arrow on the head of the device).
Operation
Q

Switching on and off

Q
Note: Always switch on the angle grinder before
bringing it into contact with the workpiece material.
Switching on the device:
P ress the safety lock-out
Then press the ON / OFF switch
Preparing for use / Operation / Maintenance and cleaning
14
to block the drive.
11
using the spanner
13
with its labelled side
15
, with its
13
to block the drive.
11
again with the
13
(see Fig. G).
3
.
2
Switching off the device:
R elease the ON / OFF switch
Rotating the hand grip:
Pull the mains plug out of the mains
socket before you carry out any task
on the device.
T he hand grip can be rotated by 90° to
1
the right or left (see Fig. A).
T his allows the ON / OFF switch
brought into the most comfortable position for
any working conditions.
P ress the unlocking button
hand grip to the right or left.
1
M ake sure the hand grip

Maintenance and cleaning

Q
Pull the mains plug out of the mains
socket before you carry out any task
on the device.
D o not use sharp objects for cleaning
the device. Do not allow any liquids
to enter the device. Otherwise the device
could be damaged.
H ave the carbon brushes replaced only at the
service centre or an accredited electrical
equipment repair centre. The device requires
no other maintenance.
C lean the device frequently; for best results do
this immediately after you have finished using it.
U se a dry cloth to clean the housing – under
no circumstances use petrol, solvents or cleaning
agents that attack plastic.
A vacuum cleaner is required to thoroughly
clean the device.
V entilation openings must always be kept free.
R emove any adhering dust with a narrow paint
brush.
.
2
DANGER OF INJURY!
to be
2
and rotate the
4
engages.
1
DANGER OF INJURY!
GB 43