Preparing For Use; Attaching The Disc Guard Cover Using The Quick-Release Fastener; Attaching The Auxiliary Handle; Attaching And Replacing Roughing / Grinding / Cutting Discs - Parkside PWS 230 A1 Betriebsanleitung

General power tool safety warnings / Preparing for use
I f a dangerous situation arises, pull
the mains plug immediately out of the
mains socket. Ensure that the device and
the mains plug are easily accessible and can
be reached quickly in an emergency.
W hen taking a break from your
work, before carrying out any tasks
on the device itself and when you are
not using the device, always pull the
mains plug out of the mains socket.
Always keep the device clean, dry and free of
oil or grease.
R emain alert at all times! Always watch
what you are doing and proceed with
caution. Do not use the device if you cannot
concentrate or you are feeling unwell.

Preparing for use

Q
Attaching the disc guard cover
Q
using the quick-release fastener
Pull the mains plug out of the mains
socket before you carry out any task
on the device.
DANGER OF INJURY! Always use the
angle grinder with the disc guard
cover in place. The disc guard cover must
be securely attached to the angle grinder. To
ensure the highest level of safety while using
the device, ensure that the smallest possible
area of the grinding or cutting tool is exposed
to the operator at all times. The disc guard cov-
er is there to protect the operator from pieces
breaking off and accidental contact with the
grinding or cutting tool.
DANGER OF INJURY! Ensure that the
guard is attached so that its edge
7
is beyond the angle of the auxiliary
handle (see Fig. B). Otherwise you
6
could injure yourself against the grinding or
cutting disc.
O pen the clamping lever
I nsert the disc cover guide
projection in the coded groove
9
42 GB
DANGER OF INJURY!
.
8
with the coded
7
.
16
T urn the disc guard cover
position (working position). The closed side of
the disc guard cover
the operator.
C lose the clamping lever
the disc guard cover
If necessary the clamping force of the connection
can be adjusted by tightening or loosening the
adjuster screw .
10
Ensure that the disc guard cover
on the spindle collar.

Attaching the auxiliary handle

Q
CAUTION! For safety reasons this
device must always be used with the
auxiliary handle
you could become injured.
Pull the mains plug out of the mains
socket before you carry out any task
on the device.
S crew the auxiliary handle
or on the top of the head of the device.
Attaching and replacing
Q
roughing / grinding / cutting discs
Take note of the dimensions of the roughing /
grinding or cutting discs. The circular hole must fit
on to the mounting flange without play. Do not use
a reducer piece or adapter.
Pull the mains plug out of the mains
socket before you carry out any task
on the device.
C heck the condition of the roughing /
grinding or cutting discs. They must be
free of damage, moisture or cracks.
Otherwise they could break up during use and
cause injury.
DANGER OF BURNS! Always wear
protective gloves when changing a
roughing / grinding or cutting disc.
Roughing / grinding and cutting discs become
into the desired
7
must always be facing
7
to firmly clamp
8
in place.
7
sits firmly
7
in place. Otherwise
6
DANGER OF INJURY!
on the left, right
6
DANGER OF INJURY!