General Safety Instructions For Compressed Air Tools; Workplace Safety; Safety Instructions - Parkside PDMS A1 Betriebsanleitung

WARNING!
► The noise emission values specifi ed in these
instructions have been measured in accordance
with the standardised measuring procedure
specifi ed in EN ISO 15744 and can be
used to make equipment comparisons. The
noise emission values vary in accordance
with the use of the compressed air tool and
may be higher than the values specifi ed in
these instructions in some cases. It is easy to
underestimate the noise emission load if the
compressed air tool is used regularly in a
certain manner.
NOTE
► For an accurate estimate of the noise emission
load during a certain working period, the
times during which the appliance is switched
off or is running but not actually being used
must also be taken into consideration. This
can signifi cantly reduce the noise emission
load over the total working period.
General safety
instructions for
compressed air tools
WARNING!
► For multiple hazards: Please ensure that you
have read and understood the safety instruc-
tions before adjusting, operating, repairing,
maintaining or replacing accessories on the
mini die grinder as well as before working in
the vicinity of the machine. Failure to do this
can result in serious bodily injury.
■ The mini die grinder should only be adjusted,
set or used by adequately qualifi ed and trained
operators.
■ This mini die grinder must not be modifi ed.
Modifi cations can reduce the eff ectiveness of
the safety measures and increase the risks for
the operator.
■ Never use damaged machines.
Save all warnings and instructions for future
reference! The safety instructions should not
be lost – give them to the operator.
PDMS A1

Workplace safety

■
Keep your working area clean and well lit.
Cluttered and dark areas invite accidents.
■ Slipping, tripping up and falling are the main
causes of injuries at the workplace. Take note
of surfaces which could have become slippery
through use of the machine, and also any trip-
ping hazards caused by air or hydraulic hoses.
■ Proceed with caution in unknown surroundings.
Hidden hazards caused by power or other supply
lines may be present.
■ Do not work with the compressed air tool
in areas subject to the risk of explosions,
or in areas where fl ammable liquids, gases
or dusts are located. Grinding work creates
sparks which may ignite the dust or fumes.
■ Keep children and other unauthorised person-
nel at a safe distance when using compressed
air tools. Distractions can cause you to lose
control.
■ The grinder is not insulated against electrical
power sources.

Safety instructions

■ Always wear eye protection when using or
servicing the grinder.
■ Always wear suitable protective clothing.
Protect your hands, hair and clothes from being
drawn in by rotating parts.
■ Always wear respiratory protection in the
presence of dust.
■ Always wear hearing protection.
■ Always wear safety gloves.
■ Only connect the grinder to the compressed air
supply when it has been switched off and when
the tool has been clamped.
■ Sparks are created during grinding. Ensure that
nobody can be endangered by fl ying sparks.
You should also remove any fl ammable materials
or objects.
■ Do not carry the grinder if it has been connected
to the compressed air hose.
■ Be aware of the hazards caused by a fl ailing
compressed air hose!
GB
23