Cleaning The Device - Cleanmaxx Z 09270 Gebrauchsanleitung

2. Pull the mains cord only as far out of the housing as you need, ideally up to the yel-
low mark, but no further than up to the red mark on the cord!
3. Insert the mains plug in a properly installed socket that is easily accessible.
4. Press the On/Off switch
5. You can individually adjust the suction power with the suction power control.
6. Move the nozzle over the surface you want to clean. You can pull the vacuum cleaner
like a sled when vacuum cleaning.
7. After vacuum cleaning, press the On/Off switch
cleaner.
8. Pull the mains plug out of the socket, fi rmly hold the mains cord and push the button
for the cord winder down with your foot. By holding the mains cord, you prevent
the cord from "lashing" against your legs for example.
9. If you used the fl oor nozzle, hook it into the bracket on the back of the device.
10. To ensure optimum performance of the device, empty the dust bin each time after
using the device and clean the dust fi lter and exhaust fi lter regularly (see chapter

"Cleaning the device").

Cleaning the device
ATTENTION!
❐ Empty the dust bin when it is full and clean the fi lters regularly to avoid overheating
the motor.
❐ Before cleaning the device, always pull the power plug out of the socket.
❐ Keep the device, cord and mains plug away from water or other liquids in order to
avoid electrical shocks. When cleaning, make sure that no liquid penetrates the
device. Only the foam dust fi lter, plastic dust fi lter and exhaust fi lter may be cleaned
with water. However, they must be completely dry when being placed back in the
device.
❐ The fi lters are not suitable for the washing machine, dishwasher or dryer! Only air
dry the fi lters and do not in any case use a hair dryer.
❐ Do not use any scouring or abrasive cleaners or cleaning pads for cleaning. They
could damage the surface.
• Clean the dust fi lter and exhaust fi lter regularly or if you notice that the suction power
is declining.
to turn the vacuum cleaner on.
Tip: Am An auxiliary air valve is located on the
handle. Slide the cover to open it, thereby reducing
the suction power if you want to vacuum off cushions,
carpets or light-weight, moveable objects or
materials.
Normally, the auxiliary air valve is closed so as not to
unnecessarily reduce the suction power.
26
again to turn off the vacuum