After Use; Cleaning The Device - Cleanmaxx VC9387S-7 Gebrauchsanleitung

EN
1. Determine where you want to start and stop cleaning without stepping on the area
of the carpet that was just cleaned. We recommend that right-handed persons start
on the right carpet border and left handed persons start on the left carpet border.
Cleaning solution may leak out of device once it is deactivated. For this reason, have
a cloth laid out that you can place the device on after use.
2. Completely unwind the mains cord from the hook (3), insert it in the cord bracket (2)
and connect it with an easily accessible socket whose mains voltage corresponds to
the device's technical data.
6. Push the device forward along the carpet border and depress the button for emitting
the cleaning solution (1). This will apply and brush the cleaning solution into the
carpet. In the process, walk next to the device. Do not step on the wet carpet! Once
you have arrived at the other end of the carpet, release the button.
7. Now go over the same strip in reverse. The dirty water will be vacuumed up.
8. Start the next strip slightly overlapping the cleaned carpet strip. Work with even
forward and backward movements up to the other edge of the carpet. In the event of
stubborn dirt, go over a strip of the carpet several times if necessary.
9. When the dirty water reservoir (11) is fi lled to the Max marking, it must be emptied
(see chapter "After Use" | "Cleaning the Device"). If you would like to empty the dirty
water reservoir, fi ll up the fresh water reservoir, or fi nish cleaning, switch off the
device by pressing the on / off switch
handle to the upright position.
10. Remove the mains plug from the mains socket.

After use

• Empty both water tanks and clean the fi lters after every use.
• Let the freshly cleaned carpet dry completely.
• Do not step on it as long as it is still wet. If this cannot be avoided, lay out white or
colour-fast cloths and step on them.
• If the cleaning solution ends up on wood fl oors or furniture, wipe it up.
• Vacuum clean the dry carpet with a vacuum cleaner. Use a brush adapter for this (if
possible).

Cleaning the device

PLEASE NOTE!
■ Before commencing the cleaning, note the safety instructions in the "Safety
Instructions" chapter!
■ The fi lters may not be cleaned in the washing machine.
■ Only air dry the fi lters and do not in any case use a hair dryer.
■ The fi lters must be completely dry after washing before you put them back in the
device.
09840_DE-EN-FR-NL_A5_V3.indb 18 09840_DE-EN-FR-NL_A5_V3.indb 18
18
3. Press down the unlocking pedal (8) and set the handle (14)
to a comfortable position.
4. Using your foot, press the on / off switch
on the device.
5. Run the device to a corner of the carpet.
, lay it on the prepared cloth, and bring the
(7) to switch
13.12.2017 15:58:33 13.12.2017 15:58:33