Use; Cleaning The Device - Cleanmaxx ND8803-1 Bedienungsanleitung

USE

Please Note!
■
To ensure that the connecting cable
does not become hot during oper-
ation, pull out at least two thirds of
the total length (yellow marking) from
the device before the vacuum cleaner
is switched on. Pull the connecting
cable out no further than the red
marking on the connecting cable to
prevent any damage!
■
The device should only be used if it
has been fully and correctly assem-
bled! The dust container, the cyclone
insert and the fi lters must be inserted
and must not be damaged! If the dirt
were to get inside the motor unit, this
could damage the motor.
■
If the MAX marking on the dust con-
tainer is reached during use, empty it.
1. Attach the suction nozzle you want
to the telescopic tube (5) or suction
hose (6) (see the "Assembly" chapter).
2. Pull the connecting cable out of the
motor unit (4).
3. Plug the mains plug into a plug
socket.
4. Press the
switch on the vacuum cleaner.
5. Guide the nozzle over the surface to
be cleaned. The vacuum cleaner can
be pulled along like a sledge during
cleaning.
 
Open the exhaust air valve (8)
on the handle (7) to reduce the
suction force when cleaning
upholstery, rugs or light, movable
objects. Normally the exhaust air
valve should be closed to prevent
the unnecessary reduction of the
suction force.
6. After vacuuming, press the
switch to switch off the device.
03040_Inlay_de-en-fr-nl_A5_V1.indb 15 03040_Inlay_de-en-fr-nl_A5_V1.indb 15
On / Off switch (18) to
On / Off
7. Pull the mains plug out of the plug
socket, hold the connecting cable
securely and press down the
for winding up the cable (15) to wind
up the cable with your foot. Holding
the connecting cable securely pre-
vents it having any "whiplash" effect,
e.g. against your legs.
8. To ensure optimum performance of
the device, empty the dust contain-
er (3) after each use and clean the
cyclone insert and fi lters regularly to
prevent the motor from overheat-
ing (see the "Cleaning the Device"
chapter).

CLEANING THE DEVICE

Please Note!
■
No liquid must be allowed to get into
the device when cleaning the device.
Only the dust container and the EPA fi l-
ter may be cleaned with water. Howev-
er, they must be completely dry before
they are put back into the device.
■
Never assemble wet or damp compo-
nents and insert them into the device!
■
Do not use any sharp or abrasive
cleaning agents to clean the device
and accessories. They may damage
the surfaces.
• Clean the housing of the vacuum
cleaner with a damp cloth if necessary.
Then wipe it dry.
• Regularly remove hair and fl uff from
the nozzles.
 
The fi lters may lose some of their
colour over time. This is normal
and does not have any adverse
effect on function.
EN
switch
15
11.02.2022 13:06:49 11.02.2022 13:06:49