Using The Pulse Function; Automatic Programmes - Bosch MMBH4 Serie Gebrauchsanleitung

7. Slowly turn the rotary switch clockwise
until the desired speed is reached. The
status LED lights up.
8. Process the ingredients until the desired
consistency is achieved.
Using the pusher
W Risk of injury!
Never use the pusher without the lid
attached!
X Fig. E
1. Turn the locking cap in an anticlockwise
direction and remove.
2. Place the pusher provided into the
opening.
3. Push the ingredients with the pusher
towards the blender knife by guiding the
pusher along the corners and sides of
the blending jug.
4. Then remove the pusher again
immediately. Put on the locking cap
and tighten it by turning in a clockwise
direction.
Note: Using the pusher can considerably
improve the quality of the blending result.

Using the Pulse function

■ With the appliance switched on, press
the Pulse button down and hold.
■ While the Pulse button is pressed, the
appliance will run at maximum speed.
■ Release the Pulse button. The
appliance will start again with the
previously selected speed.
Note: While an automatic programme is
running, the Pulse function cannot be used.

Automatic programmes

The appliance has 6 (3)* automatic
programmes (depending on the model).
After pressing the relevant button, the
programme selected starts and processes
the ingredients at preset speeds and
processing times. The programme ends
automatically after preparation.
Automatic programmes
The following programmes can be selected:
Programmes
Shake
For fruit smoothies and
milkshakes with fresh
ingredients
Smoothie For green smoothies and
fruit smoothies with frozen
ingredients
Soup For preparing hot soups
Ice cream* For ice cream and sorbets
Sauce* For sauces and dips
Cleaning*
Cleaning programme
*Depending on the model
Caution!
When the automatic programme Soup
has finished, do not restart the Soup
programme. Otherwise, the food may heat
up too much and damage the container.
Please note:
– Only use cold ingredients with the Soup
automatic programme. If hot ingredients
are added, the temperature increases
too much.
– An automatic programme can only be
started when the rotary selector is at the
zero setting.
– An automatic programme can be ended
at any time by repressing the relevant
programme selection button or by
switching off with the on/off switch.
An example
Making a pear smoothie
(recipe X "Pear smoothie" see page 22)
X Fig. F
1. Place the base unit onto a stable and
level work surface. Position the cushion
pad on to the base unit, observing the
recess.
Important: Never attach the blender jug
without the cushion pad.
2. Place the blender jug on to the cushion
pad. Make sure the blender jug is firmly
positioned on the appliance.
3. Put the desired ingredients into the
blender jug.
en
19