Using The Pulse Function - Bosch VitaMaxx MMBV6-SERIES Gebrauchsanleitung

en Use
4. The status display lights up halfway. The
preset vacuum level is reached.
5. The blender starts processing
automatically and blends the ingredients
in a pulsing rhythm. The second half of
the status display gradually lights up.
6. The blender ends processing
automatically. Wait until the appliance
comes to a standstill.
7. Switch off the appliance using
Disconnect the mains plug.
8. Open the cap completely.
9. Turn the blender jug anticlockwise and
remove.
10. Grip the vacuum seal at one end and
pull it up. Sufficient air has to get inside
the blender jug for the lid to be removed.
11. Pull the lid by the lug to remove.
12. Pour the blended food into another
container.
■ Clean all parts. X "Cleaning and
maintenance" see page 23
Note: To keep the food fresh, put it in the
ToGo bottle or storage containers after
processing and apply a vacuum again.
X "Storage with vacuum" see page 23
Manual blending with vacuum
function
X Image sequence D
1. Set the rotary selector to 0. Switch
on the appliance with
indicators light up briefly once and a
short signal tone sounds. The
lights up.
2. Press
lights up.
3. The vacuum pump draws the air out of
the blender jug. The status display LEDs
light up one by one.
Note: If the preset vacuum level is
not reached, the
up and 2 short signal tones sound.
X "Troubleshooting" see page 27
4. All status display LEDs are lit. The
preset vacuum level is reached.
22
button.
button. All
button
button. The symbol
symbol then lights
5. Set the rotary selector to the required
level or . The higher the speed, the
more status display LEDs are lit.
6. Process the ingredients until the desired
consistency is achieved.
7. Set the rotary selector to 0. Wait until
the appliance comes to a standstill.
■ Switch off the appliance using
Disconnect the mains plug.
■ Perform steps from 8. as described.
X "Blending with automatic
programme" see page 21

Using the Pulse function

■ Turn the rotary selector anticlockwise to
the position
■ The appliance will run at maximum
speed for as long as the rotary selector
is held.
■ Release the rotary selector.
Blending without vacuum
function
Prepare blender as described.
X "Preparation" see page 21
X Image sequence E
1. Set the rotary selector to 0. Switch on
the appliance with
2. Set the rotary selector to the required
level or . The symbol
The higher the speed, the more status
display LEDs are lit.
Note: During processing hold the blender
securely by putting one hand on the cap.
3. Process the ingredients until the desired
consistency is achieved.
4. Set the rotary selector to 0. Wait until
the appliance comes to a standstill.
5. Switch off the appliance using
Disconnect the mains plug.
6. Open the cap completely.
7. Turn the blender jug anticlockwise and
remove.
8. Pull the lid by the lug to remove. Pour
the blended food into another container.
■ Clean all parts. X "Cleaning and
maintenance" see page 23
button.
and hold.
button.
lights up.
button.