Starting Up; Temperature Setting - Gram MIDI FG Bedienungsanleitung

Starting up

Connect the appliance to a suitable power supply.
The numbers now shown in the display indicate the actual temperature in the cabinet
and also that power is on. The diode under indicates that the compressor is
running.
A switch is located under the illuminated top panel. When the switch is pressed, all
lights in the cabinet and the panel go out.
NOTE when servicing: If service work is performed on electrical parts, isolate the
appliance by unplugging it from the power supply.

Temperature setting

If desired, the temperature can be changed by the controller concealed behind the
light screen. (The controller is concealed to prevent the settings being tampered
with). To gain access to the controller, first remove the right hand end piece on the
illuminated panel by loosening the top and bottom screws (see drawing under
"Starting up"). The plastic light screen can now be drawn about 10 cm to the right to
give access to the controller.
Temperature check:
Press the key lightly, "set" is displayed.
Pressing the key lightly again will display the set temperature. If more than 15
seconds passes without any operation of the keys, the controller returns to normal
operation. Pressing the key will also cause a return to normal operation.
76-504-0961 13/GB