VOLTCRAFT VC281 TRMS Bedienungsanleitung Seite 65

Never use the multimeter when the battery/fuse compartment is open. DANGER OF DEATH!
Do not leave flat batteries in the device. Even leak-proof batteries may corrode and destroy the
device or release chemicals that are detrimental to your health.
Do not leave batteries unattended. They might be swallowed by children or pets. Seek immediate
medical attention if a battery is swallowed.
If you do not plan to use the multimeter for an extended period, remove the battery to prevent it
from leaking.
Leaking or damaged batteries may cause acid burns if they come into contact with your skin.
Always use protective gloves when handling leaking or damaged batteries.
Ensure that the batteries are not short-circuited. Do not throw batteries into fire!
Batteries may not be recharged or dismantled. There is a risk of explosion.
Use the following item number to order a compatible alkaline battery:
Item no. 652509 (please order 1x).
Only use alkaline batteries, as alkaline batteries are more powerful and have a longer lifespan.
Proceed as follows to insert/replace the batteries on the CLA60 clamp transformer:
- The clamp transformer requires two 1.5 V micro batteries (e.g. AAA, LR3). On initial operation or if the operating
light on the slide switch flashes or no longer lights up, insert two new, fully charged batteries.
- Disconnect the measurement adapter from the measured object and the connected test leads from your multim-
eter. Switch the adapter off (OFF).
- Open the battery compartment on the rear with a suitable screwdriver and remove the battery compartment cover.
- Replace the used batteries with new ones of the same type. Insert the new batteries into the battery compartment
(S) with the correct polarity. Look for the polarity signs in the battery compartment.
- Carefully replace the battery/fuse compartment cover.
65