Herunterladen Inhalt Inhalt Diese Seite drucken

Taking Measurements - VOLTCRAFT VC281 TRMS Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

9. Taking measurements

Never exceed the maximum permitted input values. Do not touch any circuits or circuit compo-
nents if the circuit has voltages higher than 33 V ACrms or 70 V DC. Danger of death!
Measuring is only possible when the battery and fuse compartment is closed. When the compart-
ment is open, all measurement sockets are mechanically secured against insertion.
Before measuring, check the connected test leads for damage, such as cuts, tears and kinks. De-
fective test leads must no longer be used. Danger of death!
When taking measurements, do not touch any exposed areas beyond the grip markings on the
measuring probes and the clamp transformer.
Only connect the two test leads that you require to take measurements. For safety reasons, remove
all unnecessary test leads from the device before taking a measurement.
Measurements in circuits rated at >33 V/AC and >70 V/DC must only be made by qualified and
trained personnel who are familiar with the relevant regulations and the associated hazards.
"OL" (overload) indicates that the measurement range has been exceeded.
The display shows the corresponding connection sequence of the measurement sockets for each meas-
urement mode. Observe this when connecting the test leads to the multimeter.
49

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis