Technical Data; Safety Functions - FLORABEST FKS 2200 D2 Betriebsanleitung

GB

Technical Data

Electrical chainsaw ..... FKS 2200 D2
Rated input voltage ........... 230V~, 50 Hz
Input power ...............................2200 W
Safety class ...................................
Chain speed .............................13.6 m/s
Weight
(without guide rail and chain) .........4.7 kg
Weight (with guide rail and chain) ..5.9 kg
Oiltank ....................................... 270 ml
Chain ..........................Oregon 91P057X
Chrome cutting teeth, low-kickback
Chain bar Oregon 160SDEA041 (112364)
Chain link separation ................... 10 mm
Chain width ............................... 1.3 mm
Teeth of the sprocket chain wheel ........... 7
Length of the chain bar ............... 460 mm
Sawing length ........................... 395 mm
Acoustic pressure level
(L ) .............96.0 dB(A); K
pA
Sound power level (L
measured ....... 108 dB(A); K
guaranteed ............................. 112 dB (A)
Vibration (a ) ....... 6.97 m/s
n
Noise and vibration values were deter-
mined according to the standards and
stipulations mentioned in the declaration of
conformity.
Technical and optical changes can be
carried out in the course of further develop-
ment without notice. All dimensions, refer-
ences and information of this instruction
manual are therefore without guarantee.
Legal claims, which are made on the basis
of the instruction manual, cannot thus be
considered as valid.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another.
52
=3.0 dB(A)
pA
)
WA
=3.0 dB(A)
WA
; K=1.5 m/s
2
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning:
/ II emission value may differ during
actual use of the power tool from
the stated value depending on the
manner in which the power tool is
used.
Safety precautions aimed at protect-
ing the user should be based on esti-
mated exposure under actual usage
conditions (all parts of the operating
cycle are to be considered, includ-
ing, for example, times during which
the power tool is turned off and
times when the tool is turned on but
is running idle).

Safety functions

1 Rear grip with hand guard
A
(16)
Protects the hand against branch-
2
es and boughs in the case of
springing away by the chain.
3 Chain braking lever/hand
guard
Control system, which stops the
saw chain immediately in case
of a spring-back; lever can also
be activated manually; protects
the left hand of the operator if it
slides from the front grip.
5 Saw chain with small
spring-back
Helps you to catch spring-backs
with specially developed control
systems.
7 Metal stop claw
Reinforces the stability when
vertical cuts are carried out and
facilitates sawing.
The vibration