Further Safety Directions; Operation Startup - FLORABEST FKS 2200 D2 Betriebsanleitung

GB
could result in serious personal injury.
Do not rely exclusively upon the safety
devices built into your saw. As a chain
saw user, you should take several steps
to keep your cutting jobs free from ac-
cident or injury.
Kickback is the result of tool misuse and/
or incorrect operating procedures or condi-
tions and can be avoided by taking proper
precautions as given below:
Maintain a firm grip, with thumbs
•
and fingers encircling the chain
saw handles, with both hands on
the saw and position your body
and arm to allow you to resist
kickback forces. Kickback forces can
be controlled by the operator, if proper
precautions are taken. Do not let go of
the chain saw.
Do not overreach and do not cut
•
above shoulder height. This helps
prevent unintended tip contact and ena-
bles better control of the chain saw in
unexpected situations.
Only use replacement bars and
•
chains specified by the manufac-
turer. Incorrect replacement bars and
chains may cause chain breakage and/
or kickback.
Follow the manufacturer´s sharp-
•
ening and maintenance instruc-
tions for the saw chain. Decreasing
the depth gauge height can lead to
increased kickback.

Further safety directions

• If the supply cord of this power tool is
damaged, it must be replaced by a spe-
cially prepared cord available through
the service organization.
58
• Lay the extension cable in such a way
that it will not be caught by branches
or similar during sawing.
• Use a surge protector with a release cur-
rent of 30 mA or less.
• Comply carefully with maintenance,
control and service instructions in
this manual. Damaged protective de-
vices and parts have to be repared or
changed except as noted otherwise in
this manual.

Operation startup

Always wear protective
gloves when working with
the chainsaw and employ
only original parts. Pull out
the power plug before doing
any work on the chainsaw
itself -– injury hazard!
The tool is completely assembled on deliv-
ery.Before you start up the electric chain-
saw, adjust the chain, fill up with chain oil
and check the automatic lubrication and
chain brake function.
Note that the saw can re-oil.
Please note that the saw re-oils after use
and oil may leak out if it is stored on its
side or on the head. This is a normal
process due to the necessary ventilation
opening on the upper edge of the tank and
does not constitute a reason for complaint.
As each saw is checked during production
and tested with oil, a small residue may
be in the tank despite draining, which may
slightly dirty the housing with oil in transit.
Please clean the housing with a cloth.