Causes And Operator Prevention Of Kickback - FLORABEST FKS 2200 D2 Betriebsanleitung

up in a tree may result in personal in
jury.
Always keep proper footing
•
and operate the chain saw only
when standing on fixed, secure
and level surface. Slippery or un-
stable surfaces such as ladders may
cause a loss of balance or control of
the chain saw.
When cutting a branch that
•
is under tension be alert for
spring back. When the tension in
the wood fibres is released the spring
loaded Iimb may strike the operator
and/or throw the chain saw out of
control.
Use extreme caution when cut-
•
ting brush and saplings. The slen-
der material may catch the saw chain
and be whipped toward you or pull
you off balance.
Carry the chain saw by the
•
front handle with the chain saw
switched off and away from
your body. When transporting
or storing the chain saw always
fit the guide bar cover. Proper
handling of the chain saw will reduce
the Iikelihood of accidentaI contact
with the moving saw chain.
Follow instructions for lubri-
•
cating, chain tensioning and
changing accessories.
Improperly tensioned or lubricated
chain may either break or increase the
chance for kickback.
Keep handles dry, clean, and
•
free from oil and grease. Greasy,
oily handles are slippery causing loss
of control.
Cut wood only. Do not use chain
•
saw for purposes not intended.
For example: do not use chain
saw for cutting plastic, masonry
or non-wood building materials.
Use of the chain saw for operations
different than intended could result in a
hazardous situation
Hold the power tool only on the
•
insulated handle surfaces, as the
saw chain may come into contact
with concealed power cables.
Contact between the saw chain and a
live cable may render metallic compo-
nents live and result in an electric shock
Causes and operator preven-
tion of kickback
Beware of kickback! Be careful of
kickback of the machine during
work. There is danger of injury here.
You can avoid kickbacks by exercis-
ing caution and using a correct saw-
ing technique.
Fig. 1
• Kickback may occur when the nose or
tip of the guide bar touches an object, or
when the wood closes in and pinches the
saw chain in the cut
(cf. image 1/fig. B).
• Tip contact in some cases may cause
a sudden reverse reaction, kicking the
guide bar up and back towards the op-
erator (cf. image 1/fig. A).
• Pinching the saw chain along the top of
the guide bar may push the guide bar
rapidly back towards the operator.
• Either of these reactions may cause
you to lose control of the saw which
GB
57