Operation; Stand-Alone Operation; Master/Slave Operation - EuroLite LED TMH FE-1000 Bedienungsanleitung

OPERATION

After you connected the effect to the mains, the EUROLITE LED TMH FE-1000 starts running. During the
Reset, the motors are trimmed and the device is ready for use afterwards.

Stand-alone operation

In the Stand-alone mode, the LED TMH FE-1000 can be used without controller.
Disconnect the LED TMH FE-1000 from the controller and call the internal program. Please refer to the
instructions under Control Board.

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master-
device.
On the side panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a DMX cable. Connect the DMX
OUT-jack with the DMX IN-plug of the next device.
Set the desired Master-mode for the master-device. Set the respective Slave-mode for all slave-devices.
Please refer to the instructions under Control Board.
30/39 00081193, Version 1.0