EuroLite LED TMH FE-1000 Bedienungsanleitung Seite 32

Slave setting
With this function, you can define the device as slave.
• Select "SLAV" by pressing [UP] or [DN].
• Press [ENTER], the display shows "ON" or "OFF".
• Press [UP] to select "ON" if you wish to enable this function or [DN] to select "OFF" if you don't.
• Press [ENTER] to confirm.
• Press [MODE/ESC] in order to return to the main menu.
Program Run, Master setting
With this function, you can run the internal program.
• Select "SEQU" by pressing [UP] or [DN].
• Press [ENTER], the display shows "ALON" or "MAST". The selection "ALON" means stand-alone
mode and "MAST" that the device is defined as master.
• Select "ALON" or "MAST" by pressing [UP] or [DN].
• Press [ENTER] to confirm.
• Press [MODE/ESC] in order to return to the main menu.
Music, Master setting
With this function, you can run the internal program sound-controlled.
• Select "SUND" by pressing [UP] or [DN].
• Press [ENTER], the display shows "ALON" or "MAST". The selection "ALON" means stand-alone
mode and "MAST" that the device is defined as master.
• Select "ALON" or "MAST" by pressing [UP] or [DN].
• Press [ENTER] to confirm.
• Press [MODE/ESC] in order to return to the main menu.
LAMP
• Press [MODE/ESC] to enter the main menu "LAMP" (display flashing)
• Press [ENTER] and select "TEMP" or "ADJU" by pressing [UP] or [DN].
• Press [ENTER] for selecting the desired sub menu.
Max. Temperature
With this function you can set the inside temperature at which the projector will automatically switch
the lamp/LEDs off. Inside temperatures below 90 °C are not critical. 90 °C and more should lead to
the lamp/LEDs being switched off. Please note that the outside temperature should not exceed 45
°C.
• Select "TEMP", to select the maximum inside temperature between 80 °C and 139 °C, by pressing
[UP] or [DN].
• Press [ENTER] to confirm, the display shows "90°C ".
• Press [UP] or [DN] to select "80-139°C " for the desired inside temperature.
• Press [ENTER] to confirm.
• Press [MODE/ESC] in order to return to the main menu.
INFO
• Press [MODE/ESC] to enter the main menu "INFO" (display flashing)
• Press [ENTER] and select "DRIT" by pressing [UP] or [DN].
Temperature near LED driver
With this function you can display the temperature in the projector-head (near LED driver) in degree
Celsius.
• Select "DRIT" by pressing [UP] or [DN].
• Press [ENTER], the display shows"XXXC", "X" stands for the temperature.
• Press [ENTER] to confirm.
• Press [MODE/ESC] in order to return to the main menu.
32/39 00081193, Version 1.0