Assembly Instructions - sportplus power gym Bedienungsanleitung

5. ASSEMBLY INSTRUCTIONS

Step 1
• Take all the parts out of the packaging carefully and place them on the floor.
• Be sure there is a safety clearance (mind. 1.5 m) on all sides during assembly.
Step 2: Turn over the preassembled main unit
40
24
63
52
40
13
2
35
51
44
41
51
12
44
4
44
12
44
• Place the product with its padding on a clean surface.
• Unfold the main frame 2.
• Fasten the main frame using 2 small safety pins (24).
• Rotating U-post 4 (12) and make sure align the Main frame 2 (2)'s hole site then lock
the U-post 4 (12) on the Main frame 2 (2) by the bolt (41), washer (51) and nylon
nut (35) end cap the ball nut cover (44) on the bolt (41).
• Lock the L-post(13) on the Main frame 1 (1) and the Main frame 2 (2) by the
Bolt (40), Spring washer and Washer (52).
SP-TG-001-IM-INT-06.indb 30-31
2 X (51) d8
4 X (52) d6
2 X (41) M8
4 X (40) M6
2 X (24) Ø8*31*37
4 X (44) S13
2 X (35) M8
4 X (63) d8
1
63
52
13
40
52
13
63
24
13
52
40
63
35
30
5. ASSEMBLY INSTRUCTIONS
Step 3: Assemble the stands
5
6
32
7
31
4 32
2
34
45
32
54 50
34
• Mount the large support tube (6) to the upper main frame (2) using one hex screw (45),
one washer (54) and one safety nut (50).
• Do not over tighten the nut; the support tube should still move slightly.
• Cover the screw using 2 end caps (34).
• Insert the large stand (4) into the large support tube (6).
• Screw the quick lock knob (31) into the corresponding hole and click into place.
• Unfold the small support tube (7) and fix in this position using a large safety pin (32).
• Insert the small stand (5) into the small support tube (7) and fasten using a large safety
pin (32).
• Mount the stand (3) to the lower main frame (1) using 4 carriage bolts (47),
4 washers (53) and 4 safety nuts (50).
• Cover each safety nut using an end cap (34).
47
3
47
53
50
34 53
1
34
53
50
34
1 X (54) d10
4 X (53) d10
1 X (45) M8
4 X (47)
M10*55
3 X (32) Ø10*60
5 X (34) S16
5 X (50) M10
31
17/6/2016 5:41 PM