Removing A Flush Mounted Ceiling Bracket (Optional Wb-S575) - JVC TK-C655 Bedienungsanleitung

Other

Removing a Flush Mounted Ceiling Bracket (Optional WB-S575)

3.
4.
Stoppers
5.
Push the stopper release lever
Release
upwards with a screwdriver, etc.
label
6.
E-36
<Check the release labels thoroughly before removal.>
1.
Remove the ceiling panel.
Pull down the ceiling panel and disengage the two hooks either side.
2.
Remove the camera.
Remove the camera from the Ceiling Mount by reversing the attach-
ing procedure.
☞
Clamping
bracket
3.
Loosen the clamping screws of the Flush Mounted
Ceiling Bracket.
• Loosen the three clamping screws (by turning them anti-clock-
wise).
• Make sure that the clamping brackets move inwards.
4.
Lower the Flush Mounted Ceiling Bracket until the
stoppers contact the ceiling plate.
*
5.
Push up the stopper release lever, marked (
figure, using a screwdriver.
• While holding the Flush Mounted Ceiling Bracket from below so
that it does not drop, push up the one of the three stopper release
levers marked (
• If the ceiling plate is thick and the stoppers cannot be released
easily, push up two of the stopper release levers (including the
one marked (
6.
Pull out the Flush Mounted Ceiling Bracket from the
hole in the ceiling.
Tilt the Flush Mounted Ceiling Bracket and move it obliquely down-
wards to remove it.
P. 16, "Attaching the Camera"
)using a screwdriver or a similar tool.
*
)).
*
) in the
*