Functions Of The Transmitter - ModelCraft 23 36 14 Bedienungsanleitung

Functions of the Transmitter

The producer has undertaken great efforts by the development, in order to make the
broad service spectrum of the transmitter as easy as possible to handle.
The operating instructions explains all functions for surface models but also for helicop-
ter models, it is structured in three chapters.
One describes the general introduction, the next the aeroplanes (Motor and glider
models) and the next helicopters.
Therefore read the introduction first and then only the chapter with reference to your
model type.
In most cases the programming is enabled by pressing the programming button on the
transmitter. Their functions are visible on the following picture:
Scroll the menu upwards
Bewegung im Menü nach oben
select a channel or move in the
Auswahl eines Kanals
menu to the left
oder Bewegung im Menü nach links
The parallel pressing of „INC+/YES" and „DEC-/NO" deletes a setup and puts
iit back in to the factory setting (Default).
select a channel or move in the
Auswahl eines Kanals
menu to the right
oder Bewegung im Menü nach rechts
Scroll the menu downwards
Bewegung im Menü nach unten
Figure 7
increase value, resp. Display "YES"
Wert erhöhen, bzw. Anzeige "YES"
select flight mode
Flugmodus auswählen
(helicopter)
(Hubschrauber)
decrease value,
Wert verringern,
bzw. Anzeige "NO"
resp. Display "NO"
Return to the
Rückkehr zur
prior display
vorherigen Anzeige
125