Device Hours Meter (Int, Integral Timer) - ModelCraft 23 36 14 Bedienungsanleitung

Device hours meter (INT, INTEGRAL TIMER)

The integrated device hours meter is activated with the switching on of the transmitters
and counts 99 hours, 59 minutes, 59 seconds at every time the transmitter is switched
on. It offers an outstanding display of the factual assignment time of your transmitter.
If requested a reset of the counter is possible, e.g. every time when the accumulator
package is charged.
The „INT"-Function (Integral Timer) is in the „etc"-column of the menu directly under
„STW". Press „FUNCTION- "-button, to get to the „INT" display. Please observe, that the
display already shows, how long the transmitter was switched on. The display will look
like illustrated below. The time display shows the rundown of seconds and minutes. To
set timer to zero, press the „INC+/YES" button and the „DEC-/NO"-button AT THE SAME
TIME.
If desired, the device hours meter can be selected as standard display for every channel
display, instead of using the „STW"-Display (stop watch). To operate this function from
the „INT" monitor, press the „CH+"-button, to show the following display:
Press the „INC+/YES" button and the bottom line on the display changes from „INH"
(inhibit = locked) to „ACT" (active=active). To return to „INH", either press the „DEC-
/NO"- or „INC+/YES"- button.
Most pilots prefer the display of the stop watch function to the device hours meter, that
is why they leave the „DSP" of the integral timers in „INH" (inhibit).
To return to the start-up position of the „etc"- menu column, press the „END"-button
twice.
Figure 23
Figure 24
137